EFFECT OF THE CONDENSATION WATER AT THE HYDROGEN REACTOR TO IMPROVE THE FLAME CHARACTERISTICS
DOI:
https://doi.org/10.26740/otopro.v22n1.p25-36Abstract
Oxyhydrogen (HHO) gas generated by water electrolysis offers a clean-burning alternative fuel with potential applicability in sustainable and distributed energy systems. This study investigates the performance of a wet-cell HHO generator operated using condensation water obtained from a household air-conditioning system. The reactor employs iron electrodes and an electrolyte mixture containing 3 g of NaOH, with applied voltage varied between 3-24 V to evaluate its influence on gas-generation behaviour. Hydrogen evolution is quantified using an MQ-8 gas sensor. The flame propagation is captured using a high-speed digital camera (MotionPro IDT Y3-S1, 3000 fps). Flame temperature distribution is measured via a K-type thermocouple. The hydrogen dispersion downstream of the nozzle is detected by a tracer-gas analyser. Experimental results clearly show that increasing the applied voltage significantly enhances HHO production. When the voltage is raised from 5 V to 24 V, bubble-generation frequency increases from 214.3 to 500 bubbles/min, and gas-flow rate rises from 0.1025 to 0.2392 mL/s. The volume rate increases from 6.15 to 14.35 mL/min. The flame widens and exhibits stronger luminosity at 24 V, consistent with higher hydrogen discharge rates and intensified combustion behaviour. The finding proposes that 70% purity condensation water produces approximately 15% greater performance compared with common water. This enhancement suggests that dissolved ions present in condensation water may improve ionic conductivity, reducing the activation resistance of the electrolysis process. The findings confirm that meaningful thermal output can be achieved using low-cost water sources, supporting the feasibility of economical HHO-based energy systems
References
D. M. F. Santos and C. A. C. Sequeira, “Revisão,” vol. 36, no. 8, pp. 1176–1193, 2013.
K. Zeng and D. Zhang, “Recent Progress in Alkaline Water Electrolysis for Hydrogen Production and Applications Recent Progress in Alkaline Water Electrolysis for Hydrogen Production and Applications,” pp. 1–112.
S. S. Kumar and H. Lim, “An overview of water electrolysis technologies for green hydrogen production,” Energy Reports, vol. 8, pp. 13793–13813, 2022, doi: 10.1016/j.egyr.2022.10.127.
Z. Dobó and Á. B. Palotás, “Impact of the current fluctuation on the efficiency of Alkaline Water Electrolysis,” Int. J. Hydrogen Energy, vol. 42, no. 9, pp. 5649–5656, 2017, doi: 10.1016/J.IJHYDENE.2016.11.142.
M. Rashid, M. K. Al Mesfer, H. Naseem, and M. Danish, “Hydrogen Production by Water Electrolysis : A Review of Alkaline Water Electrolysis , PEM Water Electrolysis and High Temperature Water Electrolysis,” no. 3, pp. 80–93, 2015.
C. Chatzichristodoulou, F. Allebrod, and M. B. Mogensen, “FOR I NCREASED High Temperature Alkaline Electrolysis Cells with Metal Foam,” vol. 163, no. 11, pp. 3036–3040, 2016, doi: 10.1149/2.0051611jes.
A. J. Appleby, G. Crepy, and J. Jacquelin, “HIGH EFFICIENCY WATER ELECTROLYSIS IN ALKALINE SOLUTION,” vol. 3, pp. 21–37, 1978.
N.A.Z. Putri, I. Yuliani, and S. Widarti, “Pengaruh Pemakaian Jenis Bahan Bakar Terhadap Kinerja Boiler dengan Metode Langsung dan Tidak Langsung,” J. Surya Tek., vol. 11, no. 1, pp. 349–356, 2024, doi: 10.37859/jst.v11i1.7324.
D. Burnat et al., “Composite membranes for alkaline electrolysis based on polysulfone and mineral fi llers,” J. Power Sources, vol. 291, pp. 163–172, 2015, doi: 10.1016/j.jpowsour.2015.04.066.
R. L. Leroy, “I n d u s t r i a l w a t e r electrolysis: present a n d f u t u r e,” vol. 8, no. 6, pp. 401–417, 1983.
M. R. Kraglund, D. Aili, K. Jankova, E. Christensen, Q. Li, and J. O. Jensen, “Zero-Gap Alkaline Water Electrolysis Using Ion-Solvating Polymer Electrolyte Membranes at Reduced KOH Concentrations,” J. Electrochem. Soc., vol. 163, no. 11, pp. F3125–F3131, 2016, doi: 10.1149/2.0161611JES.
J. Stojadinovi, D. Wiedenmann, M. Gorbar, F. La Mantia, L. Suarez, and A. Z, “Electrochemical Characterization of Porous Diaphragms in Development for Gas Separation,” vol. 6.
C. Acar, “Sustainability Evaluation of Solar Based Hydrogen Production Methods,” pp. 113–119, 2017.
I. Flis-kabulska, J. Flis, Y. Sun, and T. Zakroczymski, “Electrochimica Acta Hydrogen evolution on plasma carburised nickel and effect of iron deposition from the electrolyte in alkaline water electrolysis,” Electrochim. Acta, vol. 167, pp. 61–68, 2015, doi: 10.1016/j.electacta.2015.03.132.
H. A. Miller et al., “Green hydrogen from anion exchange membrane water electrolysis: A review of recent developments in critical materials and operating conditions,” Sustain. Energy Fuels, vol. 4, no. 5, pp. 2114–2133, 2020, doi: 10.1039/C9SE01240K.
S. M. M. Ehteshami, S. Vignesh, R. K. A. Rasheed, and S. H. Chan, “Numerical investigations on ethanol electrolysis for production of pure hydrogen from renewable sources,” Appl. Energy, vol. 170, pp. 388–393, 2016, doi: 10.1016/J.APENERGY.2016.03.001.
S. B. Sasongko, R. F. Huang, and C. M. Hsu, “Effects of backward inclination on a pulsed jet in crossflow,” J. Wind Eng. Ind. Aerodyn., vol. 214, p. 104662, 2021, doi: https://doi.org/10.1016/j.jweia.2021.104662.
S. B. Sasongko, R. F. Huang, and C. M. Hsu, “Modulating flow and mixing characteristics of an inclined jet in crossflow at a large backward inclination angle by acoustic excitation,” Int. J. Mech. Sci., vol. 209, p. 106708, 2021, doi: https://doi.org/10.1016/j.ijmecsci.2021.106708.
B. Concepts, “Solutions Manual for Fluid Mechanics : Fundamentals and Applications by Çengel & Cimbala INTRODUCTION AND BASIC CONCEPTS,” 2006.
D. Aili et al., “Porous poly(perfluorosulfonic acid) membranes for alkaline water electrolysis,” J. Memb. Sci., vol. 493, pp. 589–598, 2015, doi: 10.1016/J.MEMSCI.2015.06.057.
Downloads
Published
How to Cite
Issue
Section
License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Abstract views: 0
,
PDF Downloads: 0


3.png)









