SIMULASI PEMBEBANAN PADA RANGKA MESIN FUNGSI HYBRID PENGUPAS BIJIH JAGUNG BERBASIS ELEMEN HINGGA

Authors

  • SUKENDRO SASONGKO ITATS
  • HERI IRAWAN INSTITUT TEKNOLOGI ADHI TAMA SURABAYA
  • Hanif Fakhriawan Zany

DOI:

https://doi.org/10.26740/otopro.v17n2.p57-61

Keywords:

stress, strain, displacement of frame, the production process time of machine

Abstract

Preliminary investigation obtains that the elevation of the machine of about 150 cm ease man while operating the machine.  Free body diagram illustrates forces distribution on the supporting frame. Thus, virtual simulation of forces to the supporting frame applies finite element method to the stage investigating to load and stress-strain. Stress and displacement are investigated by using Von Misses method. Principal stress 1st order and 3th order also are applied for investigating stress -strain. The simulation results are revealed F1 = 17 lbf (68.6 N) and F2 = 11.023 lbf (49,03 N). The maximum stress appearing at the frame of machine is about of 0,09 Mpa. Displacement reaches maximum is at 0,01 mm. By applying safety factor to the machine frame, maximum stress to the machine frame is obtained 0,69 Mpa. So that, 1% displacement performs the machine frame is strong enough to support the machine. The timing process efficiency of multitasking machine is increase 15% higher than single tasking machine.

References

Alif AA., Muhammad Y., (2015). Jurnal Rekayasa Mesin.

Barnes, R. M. Motion and time study-design and measurement of work. John Wiley & Sons Inc, New York. 1993.

Chaffin, D. Anderson, G. Occupational Biomechanics. John Wiley & Sons Inc. Kanada. 2004.

Desi H., Bernardius H., Nessa VD., (2018). Studi eksperimental batang tarik sambungan baut pada pelat baja. Reka Racana jurnal online ITN.

Imam S., Hery I., Desmas AP., (2019). Analisis desain rangka dan penggerak alat pembulat adonan kosmetik sistem putaran eksentrik menggunakan solidwork. Prosiding Seminar Nasional.

Hery I., Bakuh S., (2020). Analisis desain kerangka mesin pengering padi rotary dryer dengan empat bantalan rol menggunakan software CAD. MEKANIKA. Jurnal Teknik Mesin.

Sukendro BS., (2013). Analisis pengaruh tebal dan arus terhadap distorsi arah transversal pada hasil las. Jurnal IPTEK ITATS 17(2) 139−149.

Sukendro BS., (2013). Analisis pengaruh tebal dan arus terhadap distorsi arah longitudinal pada hasil pengelasan pelat datar. Otopro Jurusan Teknik Mesin Unesa8 (2), 92-107.

Downloads

Published

2022-05-11

Issue

Vol 17 No 2 Mei 2022

Section

Article

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Authors who publish with this journal agree to the following terms:

    1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a  Creative Commons: Attribution-NonCommercial 4.0 International (CC BY-NC) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
    2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
Abstract views: 312 , PDF Downloads: 595